FX-1 Front chassis harness
A made-up sample job with 17 errors planted in it. Run the check and see what it finds.
What's in the job
101wires
39connectors
7splices
2ground eyelets
Pinout rev C (xlsx), drawing rev B (A1 PDF with a wire table and parts list), BOM. Deutsch DT, DTM, DTP and TE Superseal 1.5.
The 10 checks
- Pin-to-pin, both ends agree
- Missing or misspelt destinations
- Gauge, end to end and against contact size
- Colour, end to end
- Designators, pinout vs drawing
- Connector parts, pinout vs drawing
- Pin and splice usage
- BOM vs drawing and pinout, including parts list callouts
- Wire tables on the drawing
- Lengths, units and title block
Checking FX-1
Runs offline on the client version. Steps are paced here so you can follow them.
Reading pinout…0%
Wire ends read0of 201
Connectors matched0of 39, plus 7 splices
Pin pairs checked0of 101
Findings so far0see results when done
Checks
Activity
Results: FX-1 Front chassis harness
Pinout FX1-FCH-002 rev C · Drawing FX1-FCH-002 rev B · Demo rules v1.0 · Checked in seconds
Pin pairs verified
97 of 101
4 wires need a look
Findings
17
6 high7 medium4 low
Checked
201 wire ends
39 connectors · 7 splices · 2 eyelets
Time taken
Seconds
Including 29 evidence snapshots
Findings by check
Connector health · worst finding per connector, click to filter
HighMediumLowClean
All findings
F01High
Suggested fix:
FX-1 is a made-up harness. Connector families are real; the harness is not. No accuracy or time saving is claimed until proven on your work.